Innova 5310: How to perform an I/M Monitor Test

I/M Monitor Test

A Drive Cycle for a monitor requires that the vehicle is driven in such a way that all the required Enabling Criteria for the monitor to run and complete its diagnostic testing are met. You can use the 5310 to view the Drive Cycle Procedures for a selected monitor in the menu. You can also view a description of a selected monitor.

Step 1 - Press the MENU button.

To perform an I/M Monitor Test, press the MENU button.

Step 2 - Select System Tests, then press ENTER ↵.

The Main Menu will display.

Select System Tests, then press ENTER ↵.

Step 3 - Select I/M Monitor Test, then press ENTER ↵.

The System Tests menu will display.

Select I/M Monitor Test then press ENTER ↵.

Step 4 - Select your option and press ENTER ↵.

Select either the Since DTCs Cleared or This Drive Cycle option, then press ENTER ↵.

Step 5 - Select the monitor screen.

The select monitor screen lists all monitors supported by the vehicle.

Scroll down by pressing the DOWN ▼ button to view the list.

Step 6 - To know more about the chosen monitor, press the Description button.

After selecting the desired Monitor, press the Description button if you want to know more about it.

Scroll the definition using the DOWN ▼ button.

Press the MENU button to return to the Monitor Test screen.

Step 7 - Select Drive Cycle to review Drive Cycle Procedures.

	Select your preferred monitor screen and press ENTER ↵.
	Select Drive Cycle and press ENTER ↵.

Note: If Drive Cycle Procedures are unavailable for the vehicle, an advisory message will show.

Step 8 - Follow the Drive Cycle Procedures as shown on the screen.

The Drive Cycle Procedure screen shows the specific set of operating procedures that ensure the vehicle is driven so that all the required Enabling Criteria for the monitor to run and complete its diagnostic testing are met.

Scroll using the DOWN ▼ button until you are done with the last procedure.