First, connect the Innova 7111 Tablet Scan Tool Tablet to your vehicle via the On-Board Diagnostics (OBD) connector to retrieve the vehicle's information, such as Vehicle Identification Number (VIN) and model.

Then, select the function 'OBD2 Diagnostics'.

Upon accessing the 'OBD2 Diagnostics' feature on the scan tool, the display appears as shown in the image. This feature provides several essential diagnostic functions, including Reading DTCs, Erasing DTCs, Live Data, Freeze Frame, OBD Mode Tests, and Drive Cycle, among others.

The red MIL ON status icon indicates a problem with emissions and is the main reason why the vehicle will fail an emissions inspection. The fault code that triggers the MIL and its recording conditions (Freeze Frame) are crucial for the repair process.

Aside from locating the MIL DTC, also verify other retrieved DTCs, which are found in 'Stored DTC', 'Pending DTC', or 'Permanent DTC'.

A stored DTC is another type of code that can cause the Engine Control Module (ECM) to command the MIL ON. It can be the first fault of a ‘1-trip’ code or the second successive fault of a ‘2-trip’ code. If the diagnostic test passes for three successive tries, the ECM will turn off the MIL. However, this DTC will continue to be ‘stored’, and after a specified number of warm-up cycles without a recurrence, the DTC is erased from the vehicle’s memory.

A Pending DTC is a code that is set during a ‘2-trip’ cycle. A vehicle will consider the code to be a Pending DTC when the computer only sees it once during its ‘2-trip’ cycle. At this point, the MIL is not commanded ‘ON’. If the system failure is found on the second consecutive trip, the MIL is commanded ‘ON’, and Freeze Frame data is stored in the vehicle’s computer memory.

A Permanent DTC is a code that is stored when a MIL DTC is confirmed and the MIL has been illuminated. This DTC can only be cleared by a pre-set module strategy and cannot be erased by clearing/erasing DTCs with a scan tool, a Keep-Alive Memory (KAM) reset, or a battery disconnect. However, a Permanent DTC is cleared, and the MIL is turned off at the fourth monitoring cycle only after three consecutive and confirmed fault-free monitoring cycles.

After fixing any issues causing the MIL DTC and other DTCs in the vehicle, disable the MIL, and clear the (DTCs). To accomplish this, press the 'Erase DTCs' option and wait for the diagnostic tool to remove the codes from the vehicle's system.