Step 1 - Hold the Back/Power button for 3 seconds.
The instrument will switch on, the screen will display the boot screen, and the thermal image will appear after the boot screen appeared.
Step 2 - Point the thermal imager at the target area or object, and check the thermal image.
The relative temperature is shown from hot to cold through the color table (corresponding light to dark). The infrared temperature reading (shown above the thermal image) indicates the temperature of the target measuring point aimed at the cross cursor on the display screen.
Step 3 - Press the Up or Down button.
The fusion ratio of infrared and visible light can be adjusted using the Up or Down button.
Step 4 - Press the Trigger button.
When you press the Trigger button for image capture, the display screen stops, showing the thermal image at the moment. The thermal image will be surrounded by a white box.
Step 5 - After image capture, press the OK button to save the captured thermal image.
The thermal image is stored in the internal storage of the instrument in the form of pictures. The thermal image can be viewed through USB. Press the Return button to continue to scan the target area or object.
Step 6 - While in the process of scanning the area or object at which the lens is aligned, press the OK button to enter menu options.
Press OK button while scanning an area or object to show menu options, and you can set various parameters and view meter information. Press the Back/Power button to exit the menu.
Did this answer your question?Thanks for the feedbackThere was a problem submitting your feedback. Please try again later.
