Innova SDS50 SDS-Tech: Powertrain and Transmission Special Function

    Purpose

    To guide users on how to perform the Special Function while using the Innova SDS50 SDS-Tech Tablet Scan Tool.

    Introduction

    The Special Function allows you to perform diagnostic and calibration for Engine Control Module/Powertrain Control Module (ECM/PCM), Transmission Control Module (TCM) systems on various vehicles. It offers the most popular items in the Special Function available for 7 vehicle makes - Chrysler, GM, Ford, Hyundai, Nissan, Toyota, and Honda.

    This article shows the way to perform the Special Function in the ECM system on the 2015 Chevrolet Equinox.

    Procedure

    Step 1 - Connect Innova SDS50 SDS-Tech Tablet Scan Tool to the vehicle and select 'OEM Diagnostics' function

    First, connect the Innova SDS50 SDS-Tech Tablet Scan Tool to your vehicle via the On-Board Diagnostics (OBD) connector to retrieve the vehicle's information, such as Vehicle Identification Number (VIN) and model.

    Then, select the function 'OEM Diagnostics'.

    Step 2 – Performing Special Function for ECM/PCM, TCM Systems

    The Scan Tool lists all available systems in your vehicle.

    Select ‘ECM-Engine Control Module’ system to perform its Special Function.

    NOTE: The system name may vary from vehicle to vehicle.

    Tap the ‘Special Function’ button. The available specific tests vary based on the make and model of the vehicle.

    If Special Function is not supported for the vehicle under test, the message ‘Special Function is not supported’ displays. Tap ‘Exit’ button to return to the previous screen.

    Step 3 – Choose the function to perform

    The Scan Tool retrieves and displays a menu of Special Function available for the vehicle.

    Select the desired test to perform. It may take a few moments to retrieve its results.

    Follow the instructions to perform the Special Function as desired.

    Step 4 – Perform the Special Function

    Follow instructions on the screen to meet the condition of the Special Function process.

    Tap ‘Reset’ button to perform the function.

    Step 5 – Check the result

    Wait for the Scan Tool to communicate with the vehicle, after that check the result that is displayed on screen.

    When the process is completed, tap the ‘Exit’ button to finish the process.

    If the process is not completed, turn back and make sure the conditional requirement is met. After that perform the function again.

    Reference Video

    Powetrain and Transmission Special Function

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us