Innova 1000: How to check your LED Readiness for Emissions Testing

Step 1 - Select Check Engine.

  • After pairing with the RS2 App, you can now perform a Check Engine scan in the RS2 App's Home menu.

    Select Check Engine to scan the check engine codes or any error codes that turn on your check engine light.

Step 2 - Wait until the RS2 app reads the data from your vehicle.

  • The RS2 app will read the data from your vehicle, including the odometer.

Step 3 - Select Generate Report.

  • After your vehicle's odometer is read by the RS2 app, select Generate Report.
  • While generating the report for your check engine light, ensure your vehicle is turned to the ON position, and your smart device is close to your Innova 1000.

    Once the report is generated, a Done message will be shown on the screen.

Note: Your vehicle’s odometer mileage should automatically be recorded in the Odometer field.


Step 4 - LED Colors.

  • A green light indicates that all engine systems are running normally, which means that all emission monitors are active and performing their diagnostic testing, and no DTCs are present. The vehicle is ready for a Smog Check or Vehicle Emissions Inspection.
  • A yellow light indicates that there is a possible problem in one or more of the vehicle’s systems that may prevent the vehicle from passing a Smog Check or Vehicle Emissions Inspection. Either a Pending DTC is present, and/or some of the vehicle's emission monitors have not run their diagnostic testing.
  • A red light indicates a problem in one or more of the vehicle’s systems that will prevent the vehicle from passing a Smog Check or Vehicle Emissions Inspection.

    The Red LED is also used to show that DTC(s) are present as shown on the RS2 app. In this case, the Malfunction Indicator Lamp (Check Engine Light) on the vehicle's dashboard will hold steady.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us