Innova 5510: Customizing Live Data (PIDs)

Customizing Live Data (PIDs)

You can customize the number of PIDs that you wish to display by placing the 5510 in Custom Live Data mode.

With the 5510 in Live Data mode (see Viewing Live Data), press and hold LD until the Live Data Menu will display.
If the 5510 fails to establish communication with the vehicle, a Communication Error message will display. In this case:
- Ensure the vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is On.
- Turn the ignition Off, wait 5 seconds, then back On to reset the computer.
- Press POWER/LINK to continue.
If Live Data is not supported by the vehicle under test, an advisory message will display. Press the System Status button to return to the System Menu.
If Custom Live Data was not previously selected, the Live Data menu will display. Proceed to step 2.
If Custom Live Data was previously configured, then the PID selection screen will display as shown in the image.
- To use the existing Custom Live Data selections, choose Use existing PIDs, then press ENTER ↵. Proceed to step 4.
- To configure new Custom Live Data, choose Select new PIDs, then press ENTER ↵. The Custom Live Data menu will display. Proceed to step 2.

Press UP ▲ and DOWN ▼ to scroll through the available PIDs.
When a PID you wish to display is highlighted, press ENTER ↵. A Checkmark will show to confirm your selection. Repeat until only the PIDs you want to display are selected.
To select all PIDs, press Select All PIDs.
To deselect a PID, highlight the PID, then press ENTER ↵. The checkmark will be removed.

To change the current Custom Live Data selections, select Reselect PIDs, then press ENTER ↵ to return to the Custom Live Data menu. Repeat step 2.

To exit the Custom Live Data mode, press LD to return to the Live Data Menu.