Innova 5510: Viewing Drive Cycle Procedures

Viewing Drive Cycle Procedures

Performing a drive cycle for a monitor requires that the vehicle is driven in such a way that all the Enabling Criteria for the monitor to run and complete its diagnostic testing are met. You can use the Innova 5510 to view the drive cycle procedures for a selected monitor.

Step 1 - Press the MENU button.

To view your vehicle's Drive Cycle Procedures, press the MENU button.

Step 2 - Select Drive Cycle Procedures, then press ENTER ↵.

The Main Menu will display.
Scroll using the DOWN ▼ button.
Select Drive Cycle Procedures, then press ENTER ↵.

Step 3 - Select Incomplete Monitors or Complete Monitors, as desired, then press ENTER ↵ .

When the monitor status has been retrieved, the Drive Cycle Procedures menu will display.
Depending on the monitor status, you can view Drive Cycle Procedures for Complete Monitors or Incomplete Monitors.
A list of the available monitors for the selected status will display.
If no monitors for the selected status are detected, an advisory message will show.
Scroll down using the DOWN ▼ button.

Note: If Drive Cycle Procedures are not available for the vehicle, an advisory message will show.

Step 4 - Select the monitor for which you wish to view Drive Cycle Procedures, then press ENTER ↵.

Select the monitor for which you wish to view Drive Cycle Procedures, then press ENTER ↵.
A One moment please message will display while the scan tool retrieves the requested Drive Cycle Procedure.
The Drive Cycle Procedures screen for the monitor will display when the procedure has been retrieved.

Step 5 - View the Drive Cycle Procedures.

The Drive Cycle Procedure screen will show the specific set of operating procedures that ensure the vehicle is driven in such a way that all the required Enabling Criteria for the monitor to run and complete its diagnostic testing are met.
Scroll using the DOWN ▼ button until you are done with the last procedure.
When you are finished viewing the Drive Cycle Procedures, press ENTER ↵ to return to the Drive Cycle Procedures menu, or, press the MENU button to return to the Main Menu.