Innova 5410: Scanning & Viewing DTCs for Vehicle Airbag System (SRS)

Note: Refer to the manufacturer’s website for vehicle year, makes, and models covered.

Step 1 - While linked to your vehicle, press the System Status button.

While linked to your vehicle, press the System Status button to navigate to your list of scan options.

Step 2 - Press DOWN▼ to scroll to the SRS option then press ENTER ↵.

Scroll through the options in the System Menu by pressing the DOWN ▼ button and select the SRS option by pressing ENTER ↵.

Step 3 - Select Yes and press ENTER ↵ to confirm your vehicle.

Select Yes and press ENTER ↵ to confirm your vehicle.

Step 4 - Wait for the 5410 to complete the scan.

A One moment please message will display while your 5410 retrieves your SRS DTCs. Wait until the scan is 100% complete.
If the 5410 fails to link to the vehicle’s computer, a Communication Error message will show. In this case:
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC port, and that your ignition is turned ON.
- Turn the ignition OFF, wait 5 seconds, then turn the ignition back ON to reset the computer.
- Press the LINK button to continue.
If the 5410 cannot link to the vehicle’s computer after three attempts, the Contact Technical Support message will display.
- Press the System Status button to return to the System Menu.
- Turn the ignition off and disconnect your 5410 from the DLC.
- Contact Technical Support for assistance.

Note: If SRS functionality is not supported, an advisory message will show.

Step 5 - Press UP▲ or DOWN ▼ to scroll through your SRS codes.

After your tool finishes scanning, press the UP ▲ and DOWN ▼ buttons to scroll through the SRS codes.
You may refer to Display Functions for a description of each display element.
If the definition for the currently displayed code is not available, an advisory message will show.
I/M Monitor Status icons are not displayed when viewing SRS DTCs.
In the case of long code definitions, a small arrow is shown in the upper/lower right-hand corner of the code display area to indicate the presence of additional information. If no codes are present, the message No SRS DTCs are presently stored in the vehicle’s computer will show.
To exit the enhanced mode, press the System Status button to return to the System Menu.

Note: You may also press the DTC/FF button to scroll through your codes one at a time.

Step 6 - To return to your SRS codes press the DTC/FF button.

To return to your SRS codes after pressing any button, press the DTC/FF button to re-display your SRS codes.
Whenever the Scroll function is used to view additional codes, the 5410's communication link with the vehicle’s computer disconnects. To re-establish communication, press the LINK button again to rescan for SRS.

Note: Initiating another test from the System Menu such as scanning for ABS will replace the SRS codes shown with the ABS codes when you press the DTC/FF button.