Innova 5410: Scanning & Viewing OEM Enhanced DTCs on Ford/Mazda Vehicles

Purpose

To guide you on how to view OEM Enhanced DTCs while using the Innova 5410 for Ford and Mazda Vehicles.

Viewing OEM Enhanced DTCs for Ford and Mazda Vehicles

Mazda Enhanced DTCs are available for Mazda-branded Ford vehicles only. When Ford OEM Enhanced is chosen from the System Menu, the Ford OEM Enhanced menu will display. You may view DTCs for either the 'Continuous Memory Test', 'KOEO (Key On Engine Off) Test', or 'KOER (Key On Engine Running) Test.'

Step 1 - While linked to your vehicle, press the System Status button.

  • While linked to your vehicle, press the System Status button to navigate to your list of scan options. 

Step 2 - Press DOWN▼ to scroll to the OEM Enhanced option then press ENTER ↵.

  • Scroll through the options in the System Menu by pressing the DOWN ▼ button, and select the OEM Enhanced option by pressing ENTER ↵.

Note: The option should also display either Ford or Mazda as shown in the image.

Step 3 - Select 'Yes' and press ENTER ↵ to confirm your vehicle.

  • Confirm your vehicle by selecting 'Yes' and pressing ENTER ↵.

Step 4 - Wait for the 5410 to complete the scan.

  • A 'One moment please' message will display while the Scan Tool retrieves the selected DTCs. Wait until the scan is 100% complete.

Step 5 - Select the desired option, then press ENTER ↵. 

  • Select the desired option by scrolling the DOWN ▼ button, then press ENTER ↵.

    If Continuous Memory DTCs is selected, an 'instructional' message will show:

    • Turn the ignition 'Off,' then back 'On', then press ENTER ↵ to continue.
  • If KOEO or Continuous Memory is selected, an 'instructional' message will show.
    • Turn the ignition 'Off,' then back 'On', then press ENTER ↵ to continue.
  • If KOER is selected, an advisory message shows. Follow the instructional message:
    • Start and warm the engine to normal operating temperature, then press ENTER ↵ to continue.
    • Turn the steering wheel to the left, then release.
    • Press and release the brake pedal.
    • Cycle the overdrive switch (if equipped).
    • A 'One Moment please' message will display while the test is in progress.
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us