Innova 5410: Customizing Live Data (PIDs)

Purpose

To guide you on how to customize PIDS for Live Data while using the Innova 5410.

You can customize the number of PIDs that you wish to display by placing the Scan Tool in 'Custom Live Data' mode.

With the Scan Tool in Live Data mode (see Viewing Live Data), press and hold LD until the Live Data Menu will display.
If the Scan Tool fails to establish communication with the vehicle, a 'Communication Error' message will display. In this case:
- Ensure the vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is 'On.'
- Turn the ignition 'Off', wait 5 seconds, then back 'On' to reset the computer.
- Press the LINK button to continue.
If Live Data is not supported by the vehicle under test, an advisory message will display. Press the System Status button to return to the System Menu.
If custom Live Data was not previously selected, the Custom Live Data menu will display. Proceed to step 2.
If custom Live Data was previously configured, then the Select PIDs to Use screen will display as shown in the image.
- To use the existing custom Live Data selections, select Use existing PIDs, then press ENTER ↵. Proceed to step 4.
- To configure new custom Live Data, select new PIDs, then press ENTER ↵. The Custom Live Data menu will display. Proceed to step 2.

Press UP ▲ and DOWN ▼ to scroll through the available PIDs.
When a PID you wish to display is highlighted, press ENTER ↵. A 'checkmark' will show to confirm your selection. Repeat until only the PIDs you want to display are selected.
To select all PIDs, press Select All PIDs.
To deselect a PID, highlight the PID, then press ENTER ↵. The checkmark will be removed.

To change the current custom Live Data selections, select Reselect PIDs, then press ENTER ↵ to return to the Custom Live Data menu. Repeat step 2.