Innova 5410: How to Playback Live Data

Purpose

To guide you on how to playback your saved live data from the Innova 5410.

Live Data Playback

Once Live Data has been recorded, it's saved in the 5410's memory. You can view recorded Live Data immediately after recording by selecting Yes from the Record Live Data confirmation screen (see Recording Live Data for more information), or you can view it later using the Playback function using the steps below: 

Step 1 - Press the LD button.

• With the 5410 connected to the vehicle and in Live Data mode (see Viewing Live Data), press the LD button.

Step 2 - Select Playback Live Data, then press ENTER ↵.   

• The Live Data menu will display.

  Select Playback Live Data, then press the ENTER ↵ button.

Step 3 - Select Continuous Playback or Frame by Frame, as desired, then press ENTER ↵.

• The Playback Live Data menu will display. 

  Select Continuous Playback or Frame by Frame, as desired, then press ENTER ↵.

Step 4 - When Continuous Playback is selected, the 5410 will play the recorded data.

• When you select Continuous Playback, the 5410 will play the recorded data. The display will show the recorded Live Data, beginning with the Trigger frame.

  Only a limited amount of PID data can be displayed on the screen at one time. If additional PID data is available, a small arrow is shown on the display. Press UP ▲ & DOWN ▼, as necessary, to view all available PID data.

  When viewing recorded Live Data, look for any irregularities in any of the PID values/signal information (LTFT %, RPM, MAP, TEMP, etc.). If any PIDs are not within specification, or irregularities are detected, follow the procedures in the vehicle's service repair manual to perform additional troubleshooting and repair.

• When playback is finished, the screen goes back to the Playback Live Data menu, and a Playback Complete message will display.

Step 5 - When Frame by Frame is selected, you must scroll the individual frames manually.

• When Frame by Frame is selected, you must scroll the individual frames manually.
• When you have viewed all PID information for the current frame of Live Data, select Next Frame or Previous Frame, as desired, then press ENTER ↵.
• To exit Live Data Playback mode, select Exit Playback, then press ENTER ↵.