Innova 5210: Viewing Live Data

Introduction

The Innova 5210 lets you view and/or record "Real-time" Live Data. This information includes values (volts, rpm, temperature, speed, etc.) and system status information (open loop, closed loop, fuel system status, etc.) generated by the various vehicle sensors, switches, and actuators. These are the same signal values generated by the sensors, actuators, switches, and/or vehicle system status information used by the vehicle's computer when calculating and conducting system adjustments and corrections. The real-time (Live Data) vehicle operating information (values/status) that the computer supplies to the scan tool for each sensor, actuator, switch, etc. is called Parameter Identification (PID) Data. Each PID (sensor, actuator switch, status, etc.) has a set of operating characteristics and features (parameters) that serve to identify it. The Scan Tool displays this information for each sensor, actuator, switch, or status that is supported by the vehicle under test. 

If the vehicle must be driven in order to perform a troubleshooting procedure, always have a second person to help you. One person should drive the vehicle while the other person observes the Scan Tool data. Trying to drive and operate the Scan Tool at the same time is dangerous, and could cause a serious traffic accident.

Step 1 - While linked to the vehicle, start the engine, then press the LD button.

• While linked to the vehicle, start the engine, then press the LD button.

Step 2 - Wait for the 5210 to establish communication with the vehicle.

• A One moment please message will display while the Scan Tool establishes communication with the vehicle.

  If the 5210 fails to establish communication with the vehicle's computer, a Communication Error message will display.

  • Ensure the vehicle is OBD2 compliant.
  • Verify the connection at the DLC, and verify the ignition is ON.
  • Turn the ignition OFF, wait 5 seconds, then back ON to reset the computer.
  • Press ENTER ↵ to continue.

Step 3 - View your Live Data (PID) information.

• Your Real-time Live Data (PID) information will display for your vehicle.

  If Live Data is not supported by the vehicle under test, an advisory message will appear. Press the System Status button to return to the System Menu.

Step 4 - Press the UP ▲ and DOWN ▼ buttons to view all available PID data. 

• Only a limited amount of PID data can be displayed on the screen at one time.

  Press UP ▲ and DOWN ▼, as necessary, to view all available PID data. 

• To view your currently selected PID's expanded definition, press and hold down the ENTER ↵ button.

Step 5 - Selecting PIDs with Custom Live Data.

• Press The LD button to access the LD Menu.
• Select Custom Live Data, then press ENTER ↵.

• Press UP ▲ and DOWN ▼ to scroll through the available PIDs. When a PID you wish to select is highlighted, press ENTER ↵.

  Repeat until all the PIDs you want are selected. A Checkmark icon will show confirming your selection. To deselect a PID, highlight the PID, then press ENTER ↵. The checkmark is removed.

  When you are finished making your selections, press LD to continue.

Step 6 - Select Graph to view the currently selected PID as a Graph.

• Press ENTER ↵ to view the currently selected PID in Graph mode.

• The Graph mode will display. Press ENTER ↵ to return to the PID list.

  With two PIDs shown in Graph mode, press and hold LD to Superimpose one graph on the other. Release LD to separate the graphs.

• Both graphs Superimposed to each other.