Innova 5210: Drive Cycle Procedures

Viewing Drive Cycle Procedures

Performing a drive cycle for a monitor requires that the vehicle is driven in such a way that all the required Enabling Criteria for the monitor to run and complete its diagnostic testing are met. You can use the 5210 to view the Drive Cycle Procedures for a selected monitor in the menu.

Step 1 - Press the MENU button.

• Press the MENU button.

Step 2 - Select Drive Cycle Procedures, then press ENTER ↵.

• The Main Menu will display.

  Scroll down using the DOWN ▼ button and select Drive Cycle Procedures, then press ENTER ↵.

Step 3 - Select Incomplete Monitors or Complete Monitors, then press ENTER ↵.

• When the Monitor status has been retrieved, the Drive Cycle Procedures menu will display.

  Depending on the monitor status, you can view Drive Cycle Procedures for Complete Monitors or Incomplete Monitors.

• A list of available monitors for the selected choice will display.

  If no monitors for the selected status are detected, an advisory message will show.

  Scroll down using the DOWN ▼ button.

Step 4 - Select the monitor you want to view, then press ENTER ↵.

• Select the monitor you want to view the Drive Cycle Procedures for, then press ENTER ↵.

Step 5 - View the Drive Cycle Procedures.

• The Drive Cycle Procedure screen will show the specific set of operating conditions that ensure the vehicle is driven in such a way that all the required Enabling Criteria for the monitor to run and complete its diagnostic testing are met.

  Scroll down using the DOWN ▼ button until you are done viewing the last pre-condition.

• Once all the pre-conditions are viewed, press ENTER ↵ to view the Drive Cycle Procedures.
• When you are finished viewing the Drive Cycle Procedures, press ENTER ↵ to return to the Drive Cycle Procedures menu or press the MENU button to return to the Main Menu.