Innova 7111: How To Perform Electronic Parking Brake (EPB) Calibration
Purpose:
To guide you on how to perform Electronic Parking Brake Calibration while using the Innova 7111 Tablet.
Introduction
Today's Electronic Parking Brake (EPB) is popular on new cars. An EPB is an electronically controlled parking brake, whereby the driver uses the EPB button to activate the brakes to the rear wheels. The electronic control unit (ECU) and actuator mechanism are linked to accomplishing this function. There are two mechanisms in production: Cable puller systems using a mechanical pulling device in the ECU; and Caliper integrated systems that electronically actuate the brakes from within the caliper assembly.
This article shows you how to perform the Parking Brake Calibration on a 2020 Cadillac CT4 using the Innova 7111 Scan tool. Parking Brake Calibration may be required after certain service procedures are performed, such as:
- Parking brake actuator replacement
- Rear brake pad replacement
- Rear brake rotor replacement
- Rear brake caliper replacement
Procedures
Step 1 - Select "Workshop Tools"
- Turn on the ignition but do not start the vehicle.
- Connect the Innova 7111 scan tool to your vehicle via the OBD connector then the tool gets the general information automatically: VIN, model information, and odometer.
- Select "Workshop Tools".
Step 2 - Select "EPB" or the Electronic Parking Brake
- Select the "EPB" or the Electronic Parking Brake function to perform.
Step 3 - Select "BSCM - Brake System Control Module"
- On a 2020 Cadillac CT4, the Electronic Parking Brake is integrated into the Brake System Control Module. So select the BSCM to perform this function.
Step 4 - Select "Parking Brake Calibration"
- Select "Parking Brake Calibration".
Step 5 - The parking brake calibration procedure can be completed using the following steps in the Innova 7111
- After selecting "Parking Brake Calibration", the tool shows the step-by-step procedures on the screen for performing the park brake calibration.
Step 6 - Wait to the procedure
- Now the 7111 scan tool will communicate with the vehicle to perform the park brake calibration. You will need to wait as the calibration is being performed.
Step 7 - Procedure complete
- After completing all the above steps, the scan tool shows the Procedure Complete message. Your job is done.
- Apply and release the parking brakes using the park brake switch to ensure that the system is functioning.