Innova 3380: How to operate the device

Step 1 - Press and hold the Power button.

  • Press and hold the Power button for approximately two seconds, then release.
  • The power indicator lights up showing that the unit is powered on. The LCD will show the image from the snake camera.

Step 2 - Route the snake camera

Note: Make sure to take the black plastic cap off the end of the snake camera.

  • Attach the snake camera to the device and carefully route the snake camera into the location you want to observe.

Note: Do not allow the snake camera to bend at an angle greater than 60 degrees. 

Step 3 - Adjust preferred settings

Adjust the camera LED brightness, LCD display brightness and color balance, and/or image orientation, if necessary.

Step 4 - Carefully extract the snake camera, then press and release the Power button

  • After you finished viewing, carefully extract the snake camera. Press and release the Power button to turn the borescope off.
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us