Innova SD35 SD-Advisor: Playback Live Data

Purpose

To guide on you how to playback Live Data using the SD35 SD-Advisor Tablet Scan Tool.

Introduction

Once Live Data has been recorded, it is saved in the Tablet Scan Tool’s memory. You can view recorded Live Data immediately after recording by selecting Yes from the Record Live Data confirmation screen, or you can view it later using the “Playback” function.

Procedure

Step 1 - From Live Data Mode, select Live Data Menu.

• From Live Data Mode, select Live Data Menu and press OK.

Step 2 - Select Playback Live Data.

• Select Playback Live Data, then press OK.
• The Playback Live Data menu will display.
• If there is no Live Data currently stored in the Tablet Scan Tool’s memory, an advisory message will show on the display. Press View LD to return to Live Data mode.
• When you select Yes from the Record Live Data confirmation screen, the Tablet Scan Tool enters the “Live Data Playback” mode, and the Playback Live Data menu will display.

Step 3 - Select Continuous Playback or Frame by Frame, as desired.

• Select Continuous Playback or Frame by Frame, as desired, then press OK.
• The display shows the recorded Live Data, beginning with the “trigger” frame.
• Only a limited amount of PID data can be displayed on the screen at a time. If additional PID data is available, a small arrow is shown on the display. Press UP and DOWN, as necessary, to view all available PID data.

• When viewing recorded Live Data, look for any irregularities in any of the PID values/signal information (LTFT %, RPM, MAP, TEMP, etc.). If any PIDs are not within specification, or irregularities

  are detected, follow the procedures in the vehicle’s service repair manual to perform additional

  troubleshooting and repair.

Step 4 - When you select Continuous Playback, the Tablet Scan Tool plays recorded data at a rate of one frame per 2 seconds.

• Press OK on any selected PID to open a graph view for that PID.
• Select Pause to “pause” the Live Data playback. Select Play to resume the playback mode.
• Select Exit Playback to exit the Live Data Playback mode and return to the Playback Live Data menu.
• Once playback finishes, the Tablet Scan Tool automatically returns to the Playback Live Data menu.

  • To replay the data again, select Continuous Playback or Frame by Frame, as desired, then

    press OK.

Step 5 - When Frame by Frame is selected, you must scroll the individual frames manually.

• When you have viewed all PID information for the current frame of Live Data, choose Next Frame or Previous Frame, as desired.
• Press OK on any PID to open a graph view for that PID.
• To exit Live Data Playback mode, select Exit Playback at the bottom of the list, then press OK.